JT-ARM01 ARM JTAG Dongle
dongle is designed to allow communication with Arm processors.
The design allows use of a vast array of shareware software
Interface: Connect to PC via a standard 25 pin parallel (printer) port and to Arm
device through standard 20-pin (2 x 10 x 0.1”) connector.
10” cable supplied and is connectorized at both ends to permit
easy replacement of damaged cables and/or connectors.
with most Arm microcontroller J-Tag interfaces: Jumper
to accommodate software that expects NTRST to be inverted, MaCraigor
by target J-Tag interface to ensure voltage compatibility.
quiescent power supply current required is less than 40uA, typically
shifters allow 5V development stations to interface to target
processors running off voltages ranging from 3V to 5.5V.